Manual

Detaching from FABOOL Laser Mini

このエントリーをはてなブックマークに追加
original-and-extension-frame

Detaching Unit/Cables

First, cut the cable tie to remove the timing belts on x-axis and y-axis.

Next, open the PCB case and cut the cable tie that is tying the cables.

detaching-cables

Detach cables attached on the boards, as well as the right side of PCB case.
(You do not need to remove the fan from PCB case.)

removing-cables

Detach laser board and control board.

detaching-laser-board-and-control-board

 
 

Next, detach cables from the machine.
We will be only using two cables shown below.
(Please keep other cables.)

laser-cable-PCB-cable

Detach all units from the frame body, and disassemble the frame.

detaching-all-units

 

The parts you will be using are the ones shown in the picture below and screws/nuts you removed in the process above.

parts-for-extension-frame

Detaching a wheel from mini v plate

Detach all wheels from mini v plate_R and mini v plate_L on normal FABOOL Laser Mini.
(We will install these to mini v plate for 1.0m Expansion Kit later in the process.)

Use hex wrench and a spanner.

detaching-a-wheel
detaching-a-wheel
detaching-wheels

Detach all.

detaching-all-wheels
detaching-all-wheels
このエントリーをはてなブックマークに追加