Frame Set for Expansion Manual

06. Wiring

Laser cable included in 1.0m Expansion Kit is the extension of normal Laser cable. See the picture below to connect with the normal Laser cable and install corrugate tube.

wiring-for-expansion-kit
wiring-for-expansion-kit

For mounting of boards and connecting cables with PCB case, please refer to “Mounting of Boards” or “Wiring” in the manual of FABOOL Laser Mini.
Aim for the center for the installation position of PCB case. Cable tie catch should be at the red-circled position.

position-PCB-case

Fix with a cable tie catch at the red circles.

fixing-cable

Fix with a cable tie catch at the red circles.

fixing-cables

Tie the motor cables on the other side at the cable tie catch.

tying-cables

Install a cable tie catch at the red circle.

installing-cbale-tie-catch

Install a cable tie catch at the center of V-slot of x-axis.

installing-cable-tie

Install an end of corrugate tube of Laser cable in M4×40 hex socket head cap bolt with two cable ties. Fix the other end of corrugate tube at the cable tie catch installed in the center of V-slot of X-axis.

installing-corrugate-tube

See the picture below and fix Laser cable and motor cable of x-axis at the cable tie catch.

fixing-laser-cable-motor-cable

Refer to the “Installation of Laser Head” in the manual of normal FABOOL Laser Mini to install laser unit. Assembly is completed.

installing-laser-unit
Copyright 2018 smartDIYs Inc. All Rights Reserved.