FABOOL Laser CO2 Manual

Board Wiring

Laying AC Line

Parts List

laser-cable
fan-cable
power-cable

 

cable-tie-catch
post-in-nut
cap-bolt

 

cable-tie

 

Part Qty
Laser cable 1
FAN cable 1
Power cable 1
cable tie catch 10
M3 post-in nut 10
M3×6 hex socket head cap bolt 10
cable tie 10

 

 

Cable Tie Catch Attachment

 

Attach cable tie catch at position shown in the picture using M3 post-in nut and M3x6 hex socket head cap bolt.

Cable Tie Catch Attachment
Cable Tie Catch Attachment

Switching Power Wiring

Put AC-DC cable which was wired in Terminal block through the under washer socket like the picture.
Switching Power Wiring
Switching Power Wiring
Connect it to the switching power.

Switching Power Wiring

Laser Tube Wiring

Connect the laser tube and laser power.
レーザー管配線

差し込み場所
ケーブルを束ねる

Laying AC Line/Water Cooling Hose

 

Lay the AC line and water cooling hose using cable tie catch attached earlier.
(*Use more cable tie catch as needed. There are extra cable ties and cable tie catches included.)

ラジエーター側結束バンド
ラジエーター側結束バンド4か所

水冷装置側結束バンド2か所
Connect laser cable to laser power.
Laserケーブル接続

DC Line

 

Laying DC Line

 

Connect FAN cable (has two ends on both sides, white/black and red/green) to LED DC fan and water cooling pump.
(*either of two connectors of FAN cable can be connected to either of LED DC fan or water cooling pump. The shape of connectors are the same.)

Laying DC Line
Lay DC line cable using cable tie catch attached earlier.
(*Use more cable tie catch as needed. There are extra cable ties and cable tie catches included.)

Laying DC Line
Laying DC Line

Board Wiring

Connect water-resistant polyurethane tube to touch panel connector.

Board Wiring
Refer to the picture below and do the wiring of ten kinds of cables.

[X-Motor cable]
IMG_4802-1
[Y-Motor-L cable]
IMG_4804
[Y-Motor-R cable]
IMG_4805
[FAN cable]
(*Use either of the two ends.)
IMG_4807
[DC fan for radiator]
(*Use either of the two ends.)
IMG_4811
[Flow monitor]
IMG_4812
[Laser cable]
IMG_4813
[Y1-Limit cable]
IMG_4815
[Switch cable]
IMG_4817
[Power cable]
IMG_4818
[Pointer cable] (<== option: only for users who purchased positioning kit.)
IMG_4819_1
Connect panel mount USB cable to control board.
3dee58835c93a024f77d3356dc7fed87
This is the end of wiring.

Copyright 2018 smartDIYs Inc. All Rights Reserved.