FABOOL Laser DS (2018/08~) Manual

20. Cable Carrier Installation and Wiring

No. Parts Name Notes Pictures Qty
23 Cable Carrier x-axis  取付ブラケット取り外し済み 1
24 Cable Carrier y-axis  取付ブラケット取り外し済み 2
182 X-Motor Cable  
180 Y-Motor-L Cable  
181 Y-Motor-R Cable  
45 Polyurethane tube  
123 M2x8 Hex Socket Head Cap Screw   4

Assembly Procedure

Cable Carrier Wiring

Put [45]Polyurethane tube and [182]X-Motor Cable together with tape or something equivalent. Make sure that [182]X-Motor Cable is facing the right direction.

20-1.jpg

Put through the wire from the male part of [24]Cable Carrier y-axis.

20-2.jpg 20-3.jpg

ポリウレタンチューブとX-MotorケーブルにY-Motor-Lケーブルをテープ等でまとめます。Y-Motor-Lケーブルには取り付ける向きがあるので注意して下さい。

20-4.jpg 20-5.jpg

Put through the wire from the male part of [24]Cable Carrier y-axis.

20-6.jpg

Install the cables on the main body frame in the order of A through D.

20-7.jpg 20-8.jpg 20-9.jpg

Pick [45]Polyurethane tube from [182]X-Motor Cable and leave 365mm length out as shown in the picture.

20-10.jpg 20-11.jpg 20-12.jpg 20-13.jpg 20-14.jpg

Attach connector of [182]X-Motor Cable on the x-axis of [29]Stepper Motor.

20-15.jpg

Attach switch of [180]Y-Motor-L on [20]Limit Mount with 2 of [123]M2×8 Hex Socket Head Cap Screw.

20-16.jpg

Attach connector of [180]Y-Motor-L Cable on the y-axis-R of [29]Stepper Motor.

20-17.jpg

Put [181]Y-Motor-R Cables together with tape or something equivalent.

Make sure that [181]Y-Motor-R Cables are facing the right direction.

20-18.jpg

Put through the wire from the male part of [24]Cable Carrier y-axis.

20-19.jpg

Install [24]Cable Carrier y-axis on the main body frame in the order of E through F.

20-20.jpg 20-21.jpg 20-22.jpg 20-23.jpg

Attach switch of [181]Y-Motor-R on [20]Limit Mount with 2 of [123]M2×8 Hex Socket Head Cap Screw.

20-24.jpg

Attach connector of [181]Y-Motor-R Cable on the y-axis-R of [29]Stepper Motor.

20-25.jpg
Copyright 2018 smartDIYs Inc. All Rights Reserved.