FABOOL Laser DS (2018/08~) Manual

30. Tester Conduction Confirmation

No. Parts Name Notes Pictures Qty
 204 Tester   2
  電池 Included in tester box 1

Assembly Procedure

Prepartation for Tester Usage

Bring the [204]Tester out of the package.

t-30-1.jpg

Detach the screws with phillips head screwdriver.

t-30-2.jpg

Pull out the battery cable.

t-30-3.jpg

Connet the battery cable to the battery.

t-30-4.jpg

Place the battery in the container.

t-30-5.jpg

Close the cover of the battery with phillips head screwdriver.

t-30-6.jpg

Connect the test pins for tester. Black one for “COM”, and Red one for “VΩmA”.

t-30-7.jpg

Turn the center dial from the original position to the red marked area.

t-30-8.jpg

Try touching the tips of test pins and make sure the buzzer sounds.

t-30-9.jpg

Use the tester as it shown in the picture to check the cunduction.

t-30-10.jpg

Conduction Confirmation: Ground part of AC-Main Cable/ 2 kinds of Ground Cables

Referring to the picture, touch the test pins on the ground part of AC-Main Cable and [144]M5×8 Hex Socket Head Cap Screw with 2 kinds of Ground Cables installed. Conduction is confirmed when the buzzer sounds.

In case the buzzer doesn’t sound, there are possibilities that screws need to be tightened or the wiring is wrong. Try the tester again after tightening the screw and checking the wiring.

t-30-11.jpg t-30-12.jpg

Conduction Confirmation: Ground part of AC-Main Cable/ the screw located on the top left side of terminal block

Referring to the picture, touch the test pins on the ground part of AC-Main Cable and the screw located on the top left side of terminal block. Conduction is confirmed when the buzzer sounds.

※ In case the buzzer doesn’t sound, there are possibilities that screws need to be tightened or the wiring is wrong. Try the tester again after tightening the screw and checking the wiring.

t-30-13.jpg

t-30-14.jpg

Conduction Confirmation: Right terminal block of Ground part of AC-Main Cable/ Switching Power supply “+V”

Before the confirmation procedure, turn ON the switch of AC-Main Cable and Push-Button Switch.

t-30-15.jpg

Referring to the picture, touch the test pins on the right terminal block of the ground part of AC-Main Cable and Switching Power supply “+V”. Conduction is confirmed when the buzzer DOESN’T sound.

※In case the buzzer SOUNDS, DO NOT turn the power on because the battery is in short-circuit. There are possibilities that the wiring is wrong, so try the tester again after checking the wiring.

t-30-16.jpg t-30-17.jpg
Copyright 2018 smartDIYs Inc. All Rights Reserved.