FABOOL Laser Mini Manual

Assembly of X-axis / Y-axis Motor

List of Parts

assembly parts list

Part Name Part ID Qty
Stepping Motor D-5 3
motor mount plate x-axis C-1 1
motor mount plate y-axis C-1 2
Timing Pulley C-3 3
M3×6 Hexagon socket head cap bolt C-1 Screw case #(7) 12

*Please seeFABOOL Laser Mini packing listfor parts ID.

[Caution] DO NOT turn the switch on until assembly is completed.

Assembly of X-axis Motor Unit

Motor Mount Plate X-axis

Install motor mount plate x-axis on stepping motor with M3×6 Hexagon socket head cap bolt.

*For the direction of motor mount plate x-axis, make sure that two small holes are on the bottom right.

motor mount x-axis
assembly of x-axis motor unit

Installing Timing Pulley

Insert timing pulley in the spindle of stepping motor, then tighten the 2 set screws with hexagon wrench.
*Make sure that the timing pulley’s orientation is correct.
*Set screws are inserted in the timing pulley from the beginning.

assembly of timing pulley

If the timing pulley cannot be inserted smoothly, loosen the 2 set-screws with the hex wrench and try inserting again.
*Please be careful as the set screws come off easily when they are too loosened.

Insert the timing pulley fully into the spindle. (Position adjustment will be done later so exact alignment is not necessary at this point.)

installing timing pulley to x-axis motor unit
installing timing pulley to x-axis motor unit

Assembly of X-axis motor unit is completed.

motor unit is completed

Assembly of Y-axis Motor Unit

Installing Motor Mount Plate Y-axis

As shown in the picture, install the motor mount plate y-axis into the stepping motor using M3×6 hex screw socket bolt.

*Please refer to the picture to make sure that position of holes of motor mount plate y-axis are symmetry.

y-axis motor unit assembly
y-axis motor unit assembly

Installing Timing Pulley

As with the x-axis, insert the timing pulley into the spindle of stepping motor and tighten the screws.
Make sure to insert the timing pulley fully into the spindle. (Position adjustment will be done later so exact alignment is not needed at this point.)

installing timing pulley to y-axis motor unit

Assemble the other one in the same procedure, but make sure that the orientation of the motor mount plate y-axis is correct.

y-axis motor unit assembly completed

Assembly of y-axis motor unit is completed.

Go to X-axis assembly

Copyright 2018 smartDIYs Inc. All Rights Reserved.