|Laser Pointer Holder||1|
|M3×8 Hex Socket Head Bolts||1|
1: Install set screw to laser pointer holder.
2: Install laser pointer holder to lens mount using M3×8 hex socket head bolts and M3 washer.
3: Connect pointer cable and laser pointer.
4: Fix the pointer cable to polyurethane tube using cable tie like in the following picture.
1: Connect USB cable in order to let the laser pointer irradiate.
Please connect USB cable to Fabool CO2.
2: The other side of USB goes to your computer.
Please confirm laser pointer is irradiated.
3: Adjusting the place of laser letting laser irradiate, so please take the cover-top-back off.
4: Adjust pushing irradiate test button or optical adjustment button.
Please make sure you protect your eyes from laser wearing CO2 laser glasses.
5: Let irradiate laser, but please DO NOT let it for long time. Just a second is enough.
6: Adjusting the laser pointer’s laser to where the laser was irradiated.
Please check the place and angle of the laser pointer.
7:Please take the optical adjustment button off in case you are using it, and put the cover-top-back on after this adjustment process.