Smart Laser CO2 Manual

Option : Water cooling kit assembly

Assembling the water cooling kit

Attaching the device

Attach the fan to the radiator.
water-coolinh-kit

Please use the m3x28 hex socket cap bolts and M3 washers.
water-cooling-kit-assembly

Attach the hose coupler fitting to the radiator.
Attach the right cover to the radiator. Be careful of the orientation, see picture below for reference.
water-cooling-kit-assembly
water-cooling-kit-assembly

Attach the rubber stand to the water cooling pump with the self tapping screws.
water-cooling-kit-assembly

Attach the rubber feet, water cooling pump, electrical wiring board. Use the appropriate screws for each object as follows:

  • Rubber feet: M5×20 hexagon socket head cap screw, M5 nut
  • Water cooling pump: M4 × 15 hexagon socket head cap screw, M4 nut
  • Electrical wiring board: nylon spacer, nylon screws, M3 × 8 hexagon socket head cap screw
water-cooling-kit-assembly

Attaching the side covers

Insert the right and left covers into the bottom cover. Be careful of the orientation, See pictures for reference.
attaching-side-covers

Insert the back cover, be careful of the orientation.
inserting-cover-back

Insert the front cover, be careful of the orientation.
inserting-cover-front

Please fix in place using the M5 × 20 hexagon socket head bolts and M5 nuts.
water-cooling-kit-assembly

Repeat this on the opposite side also using the M5 × 20 hexagon socket head bolts and M5 nuts.
water-cooling-kit-assembly

Using the picture below for reference, fix the brass spacers in place using the M5 × 20 hexagon socket head bolts.
water-cooling-kit-assembly
water-cooling-kit-assembly

Attaching the hose

Please cut the hose to suit your working environment
attaing-hose

Cut off 200mm of hose and attach as shown in the picture below.
attaching-hose

Attach one section of hose to the cooling pump OUT.
The other end will be attached to the laser tube IN.
attaching-hose

Attach another section of hose to the radiator IN.
The other end will attach to laser tube OUT.
attaching-hose

Please fix in place for the section of hose part.
attaching-hose

Attach the hose from cooling pump OUT into the laser tube IN.
Fix in place with the cable tie.
The laser tube is made of glass so be careful not to damage it by tightening it too much
attaching-hose

Attach the tube from radiator IN to laser tube OUT. (#1 reflecting mirror side)
Fix in place with the cable tie.
The laser tube is made of glass so be careful not to damage it by tightening it too much
hose-between-radiator-and-laser-tube

Attach the flow meter to the radiator IN hose.
flow-meter-on-hose

After all the hoses have been connected to the unit, run the pump while adding water.
hose-connected

After finishing filling the system with water, attach the top cover using the M5 × 20 hexagon socket head bolts.
running-water-in-hose

Copyright 2018 smartDIYs Inc. All Rights Reserved.